Prepare a smooth, clean nail surface
A stamp transfers more reliably when the nail is clean and the layers underneath are fully set. Remove old polish, shape the free edge, and gently prepare the surface using your usual manicure routine. Avoid applying products to irritated or broken skin, and follow the directions supplied with every gel or remover.
Wipe away dust and residue before applying a base layer. Oil, lotion, or leftover cleanser can interfere with adhesion. Use thin, even coats and keep product off the surrounding skin; if gel touches the skin, clean it before curing according to the product directions.
Use compatible base and top products
Different stamping polishes and gel systems may not work together in the same way. Check that the base, colour, stamping polish, and top coat are compatible and follow each label's order of use. The BIUTEE base and top coat set is described as UV/LED compatible; use the curing guidance on its current packaging and listing.
Do not assume a product is cured because the surface feels dry, and do not extend or shorten curing time without checking the manufacturer's directions for the lamp and formula. An uncured layer may affect wear and can increase skin exposure. Keep the layers thin enough for the system's instructions to apply.
Transfer the design with a light touch
Choose a clean stamping plate and scraper, then work on one nail at a time. Apply stamping polish to the design, scrape excess with a controlled pass, and pick up the image promptly using the stamper's recommended motion. Press the image onto the nail without repeatedly sliding the stamper across the surface.
If the image is incomplete, clean the tools and try again before sealing. A thick layer of stamping polish can smear or take longer to set; a very dry plate may fail to transfer. Small test designs help you learn how the polish and stamper behave before doing all ten nails.
Seal the free edge without flooding the cuticle
Once the design is in the state specified by the stamping-polish instructions, apply the compatible top coat with a gentle pass. Avoid pressing the brush hard enough to drag the pattern. A light cap over the nail's free edge can help cover the tip when the product directions permit it, while keeping product away from skin.
Use a clean brush or the brush recommended for the top coat. If the design moves, pause and check whether it needs more time to set or whether the products are compatible. Cure only as directed for the particular gel product and lamp.
Care for the manicure after application
Give the finished nails time to settle according to the product instructions before doing chores or soaking hands. Wear suitable gloves for cleaning tasks and avoid using nails as tools. Repeated impacts, long exposure to water, and harsh chemicals can shorten wear, so protect the manicure during activities that put stress on the tips.
Do not pick or peel lifting product. If lifting, pain, redness, or another reaction appears, remove the product safely according to its directions and seek professional advice when needed. Follow local guidance for gel products and keep uncured materials away from skin and children.
Troubleshoot early chips and smudges
If a stamp chips at the tip, check whether the nail edge was covered and whether the layer thickness matched the instructions. If the design smudges, review the wait time between stamping and top coat, along with product compatibility. Change one part of the routine at a time so you can identify what improved the result.
Can I add another thick top-coat layer? Follow the product label; extra thickness may not cure as expected. Why did the stamp blur? It may have been dragged during transfer or sealing, or the polish combination may need a different set time. How can I keep the result consistent? Record the products and steps that worked, then repeat that routine with clean tools.
