Prepare a clean plate and a practice surface
The BIUTEE set is listed as 24 colors of 5 ml stamping gel polish for nail-art plates. Confirm the current package contents and read the polish label before use. Begin with a clean, dry plate and a practice tip so you can test pickup without affecting a finished manicure.
Remove residue with a method compatible with the plate and product. Work in a well-lit area and have the stamper and scraper ready before opening the polish. Keep gel away from skin and follow the manufacturer’s safety instructions, including any curing requirements.
Use a small amount and work consistently
Apply polish across the selected design and use the scraper with a controlled motion, following the tool and polish directions. Too much product can obscure fine lines, while an overly slow process may change how the polish transfers. Test one small motif first and adjust the amount or pace based on the result.
Different formulas can behave differently, so do not assume that every color has the same working time. Close bottles between tests as directed and avoid leaving product exposed longer than necessary. If the image picks up incompletely, clean the plate and repeat rather than pressing harder.
Pick up the image with a steady touch
Position the stamper over the motif and use a smooth, deliberate touch that suits the tool. Check the image before transferring it to a nail. If part of the design is missing, inspect the plate for residue, confirm that the scraper left a clear pattern, and try again on the practice surface.
Avoid repeatedly rolling or pressing hard over the same image, which can distort a fine design. Keep the plate stationary and use consistent pressure. Clean the stamper in the manner recommended for its material; some surfaces can be damaged by unsuitable solvents or scraping.
Plan transfer and curing according to the label
Once the image is picked up, transfer it as directed for the product. Follow the specific label for whether and how a layer should be cured under a UV or LED lamp. Do not infer curing time from the word “gel” or from another brand’s instructions.
Keep uncured gel off skin and clean accidental contact according to the product safety directions. If the image is too thick or smudges during transfer, reduce the amount on the next practice attempt. A successful test can help you estimate the timing before working on multiple nails.
Clean tools and store colors carefully
After the design session, clean plates, scraper, and stamper with a compatible method and let them dry before storage. Protect engraved plates from scratches and close each color container firmly. Follow the labels for temperature, light exposure, and storage.
A controlled test on a practice tip makes it easier to compare colors and pickup behavior in the 24-color set. Review the current BIUTEE product page and polish labels for exact contents and use directions before beginning a manicure.
A final checklist
Keep a note of the plate, color, and working pace that gave you a clean result. That small record can help you repeat a look without using extra product. Allow each layer to dry or cure only as directed by the specific polish label, and keep tools clean between colors.
Review the current BIUTEE set details and each bottle label before starting. Formulas, lamp requirements, and safe-use directions vary, so follow the instructions for the exact products in your kit. If product contacts skin or causes irritation, follow the label guidance and discontinue use as indicated.
Keep a note of the measurements and setup that worked so you can repeat the check next time.
Review the exact product details and directions here: Biutee Nail Stamping Gel Polish Set – 24 Colors UV LED 5ml for Nail Art Plates
